| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Fan-fret / multi-scale info needed http://luthiersforum.com/forum/viewtopic.php?f=10101&t=15414 |
Page 1 of 1 |
| Author: | Tim McKnight [ Thu Jan 17, 2008 4:47 am ] |
| Post subject: | |
Does anyone have a tutorial or pics of some POWER fret slotting sleds / jigs for multi-scale fretboards? |
|
| Author: | sharp_custom [ Thu Jan 17, 2008 5:09 am ] |
| Post subject: | |
Tim, the only thing I've seen is on Michael Doolin's website. It's a manual setup though. |
|
| Author: | Dave White [ Thu Jan 17, 2008 5:10 am ] |
| Post subject: | |
Tim, Do either of these help you: Terry Stowell Mike Doolin |
|
| Author: | James Ringelspaugh [ Thu Jan 17, 2008 5:53 am ] |
| Post subject: | |
Thanks, I've been looking for something like this as well. The table saw jig looks perfect for the task. |
|
| Author: | Brock Poling [ Thu Jan 17, 2008 6:36 am ] |
| Post subject: | |
Paul Davis has one too... you might check with him. |
|
| Author: | Tim McKnight [ Thu Jan 17, 2008 7:11 am ] |
| Post subject: | |
Thanks guys. |
|
| Author: | erikbojerik [ Fri Jan 18, 2008 12:33 pm ] |
| Post subject: | |
I print out a CAD file of the slot layout, stick it onto the fretboard blank, and cut the slots by hand with a radial arm saw using a fret slotting blade. The printed slot lines are the same width as the blade kerf (0.023"), so its very easy to see when you might be drifting off. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|