| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| cutting binding ledge? http://luthiersforum.com/forum/viewtopic.php?f=10101&t=18328 |
Page 1 of 1 |
| Author: | Jody [ Sat Aug 09, 2008 4:02 pm ] |
| Post subject: | cutting binding ledge? |
I bought LMI's binding ledge set, inside was a note saying they placed the bearing in a way the binding ledge can be cut before the purfling shelf, has anyone tried it this way ? the few builders I have talked to said they cut the purfling shelf first . thanks Jody |
|
| Author: | Brock Poling [ Sat Aug 09, 2008 4:33 pm ] |
| Post subject: | Re: cutting binding ledge? |
Jody wrote: I bought LMI's binding ledge set, inside was a note saying they placed the bearing in a way the binding ledge can be cut before the purfling shelf, has anyone tried it this way ? the few builders I have talked to said they cut the purfling shelf first . thanks Jody I use that tool. I cut the binding first. Then I recess for the side purfling (if you are going to miter around the end graft), then cut the purfling rabbet. |
|
| Author: | meddlingfool [ Tue Aug 12, 2008 1:19 pm ] |
| Post subject: | Re: cutting binding ledge? |
I always cut the binding first... |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|