I am refinishing a couple of my earlier projects and this stuff is a bear to sand off??!!!!!
A lot to be said for getting it right the first time!!!!!
| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| EM 6000 is a tough finish http://luthiersforum.com/forum/viewtopic.php?f=10101&t=38350 |
Page 1 of 1 |
| Author: | weslewis [ Sun Nov 25, 2012 5:47 pm ] |
| Post subject: | EM 6000 is a tough finish |
I am refinishing a couple of my earlier projects and this stuff is a bear to sand off??!!!!! A lot to be said for getting it right the first time!!!!!
|
|
| Author: | Robbie_McD [ Sun Nov 25, 2012 6:15 pm ] |
| Post subject: | Re: EM 6000 is a tough finish |
I just took the finish off of one of my early EM 6000 guitars. Broken weld on the truss rod..... (aagrh) I used Circa 1850 furniture stripper.... The finish came right off using a credit card as a scraper.... Low odor, needs ventilation, but don't get any on ya..... |
|
| Author: | weslewis [ Sun Nov 25, 2012 6:23 pm ] |
| Post subject: | Re: EM 6000 is a tough finish |
I used stripper on the top on one of them...just messy |
|
| Author: | bobgramann [ Mon Nov 26, 2012 9:17 am ] |
| Post subject: | Re: EM 6000 is a tough finish |
Alcohol takes it off. |
|
| Author: | Terence Kennedy [ Mon Nov 26, 2012 9:35 am ] |
| Post subject: | Re: EM 6000 is a tough finish |
What kind of truss rod? |
|
| Author: | Robbie_McD [ Wed Nov 28, 2012 8:09 am ] |
| Post subject: | Re: EM 6000 is a tough finish |
Terence Kennedy wrote: What kind of truss rod? It was a 1/4" double-action with the flat bar on top from one of our major suppliers. There was exactly zero penetration on the weld. I always test before install for functionality - now I think I will test between two large chunks of wood for strength.... Sorry for the hijack Wes! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|