| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Router Bit Sharpening http://luthiersforum.com/forum/viewtopic.php?f=10101&t=39858 |
Page 1 of 1 |
| Author: | Goat Rock Ukulele [ Wed Mar 27, 2013 11:01 am ] |
| Post subject: | Router Bit Sharpening |
Does anyone know a good place to send a binding channel bit to be sharpened. I realize they will come back a little smaller but I should have enough bearings to cover that. |
|
| Author: | B. Howard [ Wed Mar 27, 2013 11:30 am ] |
| Post subject: | Re: Router Bit Sharpening |
I send my router bits out with my saw blades to Forrest. http://www.forrestblades.com/ |
|
| Author: | Josh H [ Wed Mar 27, 2013 12:26 pm ] |
| Post subject: | Re: Router Bit Sharpening |
They are easy to sharpen with a diamond hones, like these ones from LV http://www.leevalley.com/en/wood/page.aspx?p=33007&cat=1,46168,46180 or http://www.leevalley.com/en/wood/page.aspx?p=70638&cat=1,43072,43077 You just sharpen the flat face and make sure to take an equal number of passes on all blades. It doesn't take more than a minute or two to put a nice sharp edge back on your cutter. Josh |
|
| Author: | Colin North [ Wed Mar 27, 2013 2:54 pm ] |
| Post subject: | Re: Router Bit Sharpening |
+1 on the above! 3+ mm Dremel bits, binding bit,trim bits. Virtually everything except my spiral downcut bit (so far!) |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|