Official Luthiers Forum! http://luthiersforum.com/forum/
Laminated binding question... http://luthiersforum.com/forum/viewtopic.php?f=10101&t=44700	Page 1 of 1

---

Author:	meddlingfool [ Mon Dec 08, 2014 4:30 am ]
Post subject:	Laminated binding question...
When doing lam bindings, how do you account for the radius or downward slope that happens at the waist without getting a gap?

---

Author:	Tom West [ Mon Dec 08, 2014 7:03 am ]
Post subject:	Re: Laminated binding question...
Less height in the binding. Tom

---

Author:	Terence Kennedy [ Mon Dec 08, 2014 8:55 am ]
Post subject:	Re: Laminated binding question...
That old rule of woodworking, "If it doesn't fit force it."

---

Author:	Tom West [ Mon Dec 08, 2014 9:54 am ]
Post subject:	Re: Laminated binding question...
Terence brings up a good point.................................roping or binding is better then tape. Tom

---

Author:	Burton LeGeyt [ Mon Dec 08, 2014 10:01 am ]
Post subject:	Re: Laminated binding question...
Laminated bindings or linings?

---

Author:	EddieLee [ Mon Dec 08, 2014 10:40 am ]
Post subject:	Re: Laminated binding question...
I too wonder what you exactly what you are referring to as laminated bindings. Can you give a fuller description of what you are doing?

---

Author:	Barry Daniels [ Mon Dec 08, 2014 10:46 am ]
Post subject:	Re: Laminated binding question...
I put a little sideways bend in the binding at the waist which allows it to fit much better.

---

Author:	meddlingfool [ Mon Dec 08, 2014 1:09 pm ]
Post subject:	Re: Laminated binding question...
Doh! I meant linings... I'll start again...

---

Author:	Tom West [ Mon Dec 08, 2014 2:21 pm ]
Post subject:	Re: Laminated binding question...
Thought you were talking about binding with side purflings glued to the bottom..................carry on Tom

---

Page 1 of 1	All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/