Josh H wrote:
Green painters tape for me. I always have it around the shop anyway and it comes off clean.
Just don't put it near the waist. DAMHIK
| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Tape Stuff http://luthiersforum.com/forum/viewtopic.php?f=10101&t=44968 |
Page 1 of 1 |
| Author: | Terence Kennedy [ Thu Jan 22, 2015 1:57 pm ] |
| Post subject: | Tape Stuff |
The last several times I have bent binding I used 3M 2080EL Edge Lock tape to hold the pieces together. It worked great and came off easily compared to other tapes I have used, the brown binding tape being the worst. Good stuff for taping binding together for bending in the bender. |
|
| Author: | Tom West [ Thu Jan 22, 2015 2:46 pm ] |
| Post subject: | Re: Tape Stuff |
Terence: Thanks for that info...! I use regular masking tape and it is a bear to remove after going through the bender. Will give this a try next time. Tom |
|
| Author: | Joe Beaver [ Thu Jan 22, 2015 3:33 pm ] |
| Post subject: | Re: Tape Stuff |
I do know about getting tape off after it has melted in. Very difficult. Now I just cut strips of paper and wrap tightly, followed by a little masking tape. Works for me |
|
| Author: | Josh H [ Thu Jan 22, 2015 10:08 pm ] |
| Post subject: | Re: Tape Stuff |
Green painters tape for me. I always have it around the shop anyway and it comes off clean. |
|
| Author: | DannyV [ Thu Jan 22, 2015 10:37 pm ] |
| Post subject: | Re: Tape Stuff |
Josh H wrote: Green painters tape for me. I always have it around the shop anyway and it comes off clean. Just don't put it near the waist. DAMHIK
|
|
| Author: | unkabob [ Fri Jan 23, 2015 12:15 am ] |
| Post subject: | Re: Tape Stuff |
Mineral spirits (varsol) should remove the melted in adhesive. Bob 
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|