wbergman wrote:
On an Internet search, I found a motorcycle parts plater that can do small parts for $15 to $40. It was in California. See if you can search for one near you.
Thus far the cheapest has been $85.00 Minimum
| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Chrome Plating http://luthiersforum.com/forum/viewtopic.php?f=10101&t=45071 |
Page 1 of 1 |
| Author: | WudWerkr [ Thu Feb 05, 2015 2:45 pm ] |
| Post subject: | Chrome Plating |
I want to make a custom truss rod cover for my electric build . Do any of you guys do any chrome plating , or has anyone ever tried the DIY kits that are available ? |
|
| Author: | wbergman [ Thu Feb 05, 2015 4:49 pm ] |
| Post subject: | Re: Chrome Plating |
On an Internet search, I found a motorcycle parts plater that can do small parts for $15 to $40. It was in California. See if you can search for one near you. |
|
| Author: | WudWerkr [ Thu Feb 05, 2015 5:12 pm ] |
| Post subject: | Re: Chrome Plating |
wbergman wrote: On an Internet search, I found a motorcycle parts plater that can do small parts for $15 to $40. It was in California. See if you can search for one near you. Thus far the cheapest has been $85.00 Minimum
|
|
| Author: | Peebs [ Fri Feb 06, 2015 8:38 am ] |
| Post subject: | Re: Chrome Plating |
I'll check out the plater here in JC. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|