Official Luthiers Forum! http://luthiersforum.com/forum/
Fuji Spray System http://luthiersforum.com/forum/viewtopic.php?f=10101&t=47967	Page 1 of 1

---

Author:	jsmith [ Fri Jul 01, 2016 1:33 pm ]
Post subject:	Fuji Spray System
I have a Mini Mite 4, and I'm in the market for a new gun. My old one has an H4 air cap. But I see that their standard issue gun is equipped with an H3 cap, and it's also rated for nitro. Is anyone else here shooting nitro through a Fuji HVLP spray system? If so, which size air cap are you using--H3 or H4?

---

Author:	Jim Watts [ Fri Jul 01, 2016 3:17 pm ]
Post subject:	Re: Fuji Spray System
I spray with an older Fuji system. It came with an H3 but since I've changed to an H4 and seem to get better results.

---

Author:	Woodie G [ Fri Jul 01, 2016 4:50 pm ]
Post subject:	Re: Fuji Spray System
We have the Fuji four stage turbine and have used the XPC and T-75G guns for lacquer and waterbased finishes. The 1.3mm aircap/needle set for the T-75G does a nice job on lacquer - on par with the Iwata and SATA conversion guns in the shop. While the 1.3mm set will spray waterbased, the 1.0mm does a better job atomizing finishes like Enduro-Var. All stainless fluid passages, etc. The T-75G runs about $319 via Amazon Prime. If converting to the PPS system, the #2 adaptor works (same as Iwata full-sized guns use).

---

Author:	WaddyThomson [ Fri Jul 01, 2016 10:02 pm ]
Post subject:	Re: Fuji Spray System
FWIW, there is a recent discussion on Fuji HVLP systems and guns on MIMF Forum this week. You might want to check it out.

---

Author:	jsmith [ Fri Jul 01, 2016 10:13 pm ]
Post subject:	Re: Fuji Spray System
Thanks, gentlemen!

---

Author:	klooker [ Sat Jul 02, 2016 10:17 am ]
Post subject:	Re: Fuji Spray System
Mine came with a 4 but I changed to a 3 and feel I get better results with Mohawk stringed instrument lacquer, but of course, YMMV.

---

Page 1 of 1	All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/