| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Martin Cutaway http://luthiersforum.com/forum/viewtopic.php?f=10101&t=48420 |
Page 1 of 1 |
| Author: | EddieLee [ Mon Oct 17, 2016 12:54 pm ] |
| Post subject: | Martin Cutaway |
Can anyone tell me how Martin does the right angle joint between the cutaway section and the section along the top of the guitar (under the neck heel)? I have looked at this many time and can not see a where it is jointed together. The grain seems to run though the joint. http://s269.photobucket.com/user/elb_fl ... 4.jpg.html 
|
|
| Author: | Colin North [ Mon Oct 17, 2016 2:47 pm ] |
| Post subject: | Re: Martin Cutaway |
Most likely it's mitred then. |
|
| Author: | Ken Lewis [ Mon Oct 17, 2016 3:11 pm ] |
| Post subject: | Re: Martin Cutaway |
I like to do them that way, just mitered for a good tight fit. Nice and clean IMO. Ken |
|
| Author: | bftobin [ Mon Oct 17, 2016 9:11 pm ] |
| Post subject: | Re: Martin Cutaway |
Mitered for a nice tight fit, and then GENTLY roll the edges. It will look like all one piece IF done properly Brent |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|