Good to know. 4&3 is pretty low! I bet it was easy peasy to play.
Sent from my iPhone using Tapatalk
| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Set up for "tapping" on an Acoustic. http://luthiersforum.com/forum/viewtopic.php?f=10101&t=48581 |
Page 1 of 1 |
| Author: | Colin North [ Wed Nov 23, 2016 3:50 am ] |
| Post subject: | Set up for "tapping" on an Acoustic. |
Curious. What would be your typical measurements for 6th/1st action at the 12th fret when setting an Acoustic for double-handed tapping? |
|
| Author: | Colin North [ Thu Nov 24, 2016 6:29 am ] |
| Post subject: | Re: Set up for "tapping" on an Acoustic. |
FWIW, I did a complete refret on a Martin (Evo 43080 wire) out the door yesterday at 1.4/1.2 mm (just shy of 4/64th and 3/64ths) with Elixir nanoweb 47-10's. Relief was a bit more than my usual at around 0.012/0.008 bass/treble. Although it was intended for an owner who likes a low action, I noticed it "tapped" much better than my own beaters, so I just wondered about what others had found worked for them. |
|
| Author: | bcombs510 [ Thu Nov 24, 2016 11:13 am ] |
| Post subject: | Re: Set up for "tapping" on an Acoustic. |
Good to know. 4&3 is pretty low! I bet it was easy peasy to play. Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|