Official Luthiers Forum!
http://luthiersforum.com/forum/

Guild bridge shape
http://luthiersforum.com/forum/viewtopic.php?f=10101&t=48672		 Page 1 of 1
Author:  Jonny [ Sun Dec 11, 2016 5:21 pm ]
Post subject:  Guild bridge shape
Howdy,

Looking for a Guild bridge template or a good picture that I can transfer to a template

Cheers Jonny
Author:  jfmckenna [ Sun Dec 11, 2016 6:47 pm ]
Post subject:  Re: Guild bridge shape
I just happen to be making one right now to replace one that someone shaved down too far instead of doing a neck reset. If it looks like the one below then I could trace it for you and mail or just photograph it unless someone else has another solution.

Image
Author:  Ken Lewis [ Sun Dec 11, 2016 7:24 pm ]
Post subject:  Re: Guild bridge shape
Got a copier scanner?
Trace, put measurements on, scan, save to .jpg and post here.
Ken
Author:  jfmckenna [ Mon Dec 12, 2016 9:00 am ]
Post subject:  Re: Guild bridge shape
Yeah I suppose I could do that too. But isn't there some discrepancy between print and jpeg and sizing and all that?
Author:  kencierp [ Mon Dec 12, 2016 9:40 am ]
Post subject:  Re: Guild bridge shape
This is the Guild shape I have used in the past and the same as shown in Guild's replacement parts catalog -- there is a full size drawing in David Russel Young's construction book.

Image
Author:  jfmckenna [ Mon Dec 12, 2016 10:50 am ]
Post subject:  Re: Guild bridge shape
Yeah they have gone through some changes. The one I pictured above is from a 60's D-40. The pin holes are drilled at a 10deg angle too.
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/