| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Thickness sanding on Long Island? http://luthiersforum.com/forum/viewtopic.php?f=10101&t=49097 |
Page 1 of 1 |
| Author: | oval soundhole [ Mon Mar 06, 2017 10:28 pm ] |
| Post subject: | Thickness sanding on Long Island? |
I hope it's ok to post this but I was wondering if anyone here knew of any shops on Long Island that might be willing to sell me access to a thickness sander to sand a euro maple back and side set. Normally I'd have no problem thicknessing this by hand but due to a recent shoulder injury I don't think I have the endurance to spend a few hours planing. |
|
| Author: | Steve Marcq [ Tue Mar 07, 2017 11:24 am ] |
| Post subject: | Re: Thickness sanding on Long Island? |
I would check with local cabinet shops, they likely have a wide-belt sander and many will rent you a bit of time if you ask nice. |
|
| Author: | Brad Goodman [ Tue Mar 07, 2017 1:33 pm ] |
| Post subject: | Re: Thickness sanding on Long Island? |
Hi Steve, I live in Brewster NY. probably around 1-1/2 - 2 hours from L.I.. You are welcome to use my widebelt if you want. Regards, Brad |
|
| Author: | Bri [ Tue Mar 07, 2017 6:59 pm ] |
| Post subject: | Re: Thickness sanding on Long Island? |
Nice, Brad I assume that offer extends to all OLFers. I know that I owe some pay-it-forward from all the knowledge gleaned from here. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|