I get my holly , rosewood, black dyed castello , and other veneers from certainly wood veneer in aurora NY fast friendly efficient service . Good prices .
| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| b/w/b purfling veneer source http://luthiersforum.com/forum/viewtopic.php?f=10101&t=49298 |
Page 1 of 1 |
| Author: | surveyor [ Sat Apr 29, 2017 4:51 pm ] |
| Post subject: | b/w/b purfling veneer source |
I want to start laying up my own b/w/b purfling and would appreciate any info on where to buy the veneers. I've seen a lot on E-Bay but not sure about them. I prefer some that won't "run" or bleed into the spruce when French Polished. |
|
| Author: | rlrhett [ Sat Apr 29, 2017 10:11 pm ] |
| Post subject: | Re: b/w/b purfling veneer source |
I've used this stuff, and never had runs with FP. I'm sure I'll say that and the next batch will run like Usain Bolt, but for now they have worked well. Ordered twice, about ten sheets of black/ ten of white each time. http://www.dyed-veneer.com/dyed_veneers.aspx Sent from my iPhone using Tapatalk |
|
| Author: | bcombs510 [ Sun Apr 30, 2017 6:58 am ] |
| Post subject: | Re: b/w/b purfling veneer source |
Maybe the fiber veneer from RC? They are a forum sponsor. I use the 0.020 thick when making binding that has purfling attached. Get a zero clearance fitting for your bandsaw and slice them up! http://rctonewoods.com/RCT_Store/fiberv ... 3ivvtbaiu1 Sent from my iPhone using Tapatalk |
|
| Author: | ernie [ Sun Apr 30, 2017 7:28 am ] |
| Post subject: | Re: b/w/b purfling veneer source |
I get my holly , rosewood, black dyed castello , and other veneers from certainly wood veneer in aurora NY fast friendly efficient service . Good prices .
|
|
| Author: | Alan Carruth [ Thu May 04, 2017 12:38 pm ] |
| Post subject: | Re: b/w/b purfling veneer source |
LMII sells dyed veneers, in both .5 and .3mm thickness, including black. I like to get maple veneer locally for the white. You can often find curly veneer, which, since it's generally flat cut, means that the curl shows most effectively on the edge grain that you'll be seeing in the layup. You can also sometimes find ~.8mm ( the old American standard thickness of 1/28") stock, which gives you more choices of line widths. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|