Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
Getting circles straight http://luthiersforum.com/forum/viewtopic.php?f=10101&t=50309 |
Page 2 of 2 |
Author: | Bri [ Thu May 03, 2018 9:00 pm ] |
Post subject: | Re: Getting circles straight |
Or, get one of these from Edmonton area luthier Len Letorneau. http://www.letourneauguitars.com/wp-con ... C_5199.jpg B |
Author: | Brad Goodman [ Sat May 05, 2018 8:03 am ] |
Post subject: | Re: Getting circles straight |
Terence Kennedy wrote: I cut out the sound hole with a circle cutting jig at slow RPM for many years. Now I use the router with a climb cut and the edge is a lot smoother over the end grain. I think John Greven used a multiple cut adjustable rosette jig that LMI marketed. Not sure if he still is. Anyone here ever try that tool? http://www.lmii.com/products/tools-serv ... tte-cutter I have been using the Greven/LMI Circle cutter for many years now and I love it. The only downside is of course that you can only use it for the same rosette without changing out the cutters. It literally takes a few minutes to use. Sent from my iPhone using Tapatalk |
Page 2 of 2 | All times are UTC - 5 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |