| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Anyone know what this thing is? http://luthiersforum.com/forum/viewtopic.php?f=10101&t=51062 |
Page 1 of 1 |
| Author: | bcombs510 [ Tue Oct 02, 2018 1:59 pm ] |
| Post subject: | Anyone know what this thing is? |
https://youtu.be/gS78naDiB4k?t=1092 It's like some kind of miter saw outfitted with an abrasive cutting wheel or something? Actually, the rate the material is removed I don't know if it could be abrasive. It's cool though! |
|
| Author: | SteveSmith [ Tue Oct 02, 2018 2:19 pm ] |
| Post subject: | Re: Anyone know what this thing is? |
You can see it at 22:45. Looks like a homemade gang saw or sanding disk. Just a quick way to do the job. |
|
| Author: | Brad Goodman [ Tue Oct 02, 2018 2:22 pm ] |
| Post subject: | Re: Anyone know what this thing is? |
It appears to be a dado blade....... |
|
| Author: | Ruby50 [ Tue Oct 02, 2018 6:05 pm ] |
| Post subject: | Re: Anyone know what this thing is? |
+1 with Brad. A carbide dado blade makes very smooth, flat bottomed cuts. 8 inch diameter? Ed |
|
| Author: | Clay S. [ Tue Oct 02, 2018 7:40 pm ] |
| Post subject: | Re: Anyone know what this thing is? |
I'm surprised they cut the sides to accept the braces. After the dado blade it looked like he pared the ends down to nothing with the chisel. |
|
| Author: | Bri [ Tue Oct 02, 2018 8:03 pm ] |
| Post subject: | Re: Anyone know what this thing is? |
Dado was my first thought also B |
|
| Author: | B. Howard [ Wed Oct 03, 2018 4:42 am ] |
| Post subject: | Re: Anyone know what this thing is? |
Dado blade, a wobbler it looks like rather than a stack but a dado blade is what I see. |
|
| Author: | Ruby50 [ Wed Oct 03, 2018 11:22 am ] |
| Post subject: | Re: Anyone know what this thing is? |
And this opens the age-old discussion of letting the braces into the lining or squashing the ends when you glue on the plates Ed |
|
| Author: | bcombs510 [ Wed Oct 03, 2018 11:28 am ] |
| Post subject: | Re: Anyone know what this thing is? |
Ruby50 wrote: And this opens the age-old discussion of letting the braces into the lining or squashing the ends when you glue on the plates Ed I tuck every brace including the finger braces. My guitars are often described as "tight". I think the kids use that as slang for "nice". 
|
|
| Author: | Rocky Road [ Thu Oct 04, 2018 12:41 pm ] |
| Post subject: | Re: Anyone know what this thing is? |
That is a cut-off saw, called a swing saw, iirc. Yeah, with a dado blade set. clever way to cut the brace ends. Watch those fingers! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|