Official Luthiers Forum!
http://luthiersforum.com/forum/

Vacuum fixture making a vacuum fixture
http://luthiersforum.com/forum/viewtopic.php?f=10106&t=37819
Page 1 of 1

Author:  Sheldon Dingwall [ Mon Sep 24, 2012 8:27 pm ]
Post subject:  Vacuum fixture making a vacuum fixture

This impressed me today. I needed a pair of outboard vacuum supports to hold neck fixtures on my main vacuum table. Milled the parts this far with just vacuum hold down - no index pins. I had enough surface area that the workpiece held solid slotting with a 1/2" cutter.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/