![[clap]](./images/smilies/smiley32.gif "adulations")
Well done Todd! Can't wait to see that one finished. Thanks for the tutorial!
| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| One Method for Milling Glued-Up Burl Rosette Rings http://luthiersforum.com/forum/viewtopic.php?f=10117&t=15913 |
Page 1 of 1 |
| Author: | Terry Stowell [ Fri Feb 15, 2008 10:51 am ] |
| Post subject: | Re: One Method for Milling Glued-Up Burl Rosette Rings |
| Well done Todd! Can't wait to see that one finished. Thanks for the tutorial!
|
|
| Author: | Hesh [ Fri Feb 15, 2008 11:09 am ] |
| Post subject: | Re: One Method for Milling Glued-Up Burl Rosette Rings |
Very nicely done toot ("one method") Todd! Many thanks! Tony Soprano would be proud of the care you took when cutting up Burl Ives on a band saw........ 
|
|
| Author: | James Orr [ Sat Feb 23, 2008 4:35 pm ] |
| Post subject: | Re: One Method for Milling Glued-Up Burl Rosette Rings |
What a beautiful rosette in waiting. It makes me a bit dissatisfied with the red abalone heart I'm getting ready to put in a redwood top ![[:Y:]](./images/smilies/smiley20.gif "Thumbs Up")
|
|
| Author: | Mattia Valente [ Wed Apr 02, 2008 4:19 am ] |
| Post subject: | Re: One Method for Milling Glued-Up Burl Rosette Rings |
As an alternative, I've had very good luck joining rosette blanks using the 'tent' method used for tops (masking tape). If the joint's tight, a few strips of stewmac brown masking tape will do wonders. Recently used it to make a cavity cover blank for an electric from some offcuts that were not wide enough on their own, and I needed a good grain/colour match. |
|
| Author: | Chris Paulick [ Mon Sep 22, 2008 8:06 pm ] |
| Post subject: | Re: One Method for Milling Glued-Up Burl Rosette Rings |
Great tutorial as usual Todd. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|