Official Luthiers Forum!
http://luthiersforum.com/forum/

New tenor ukelele build
http://luthiersforum.com/forum/viewtopic.php?f=10128&t=37856
Page 1 of 1

Author:  Tai Fu [ Fri Sep 28, 2012 2:02 pm ]
Post subject:  New tenor ukelele build

I will be building a tenor uke at this time... no plans or forms but I hope to find one online that I can reasonably duplicate... I can't order from Stewmac or LMI at this point so I will need to work with what I have...

Here is what I plan to use:

Top: Reclaimed (as in found on the sidewalk) wood, what appears to be Western Red Cedar, at least it smells like it...
Back/Side: Padauk from my last uke challenge
Neck: Mahogany
Fingerboard: Probably ebony
Trims: Curly maple, and bwb purflings

I really need to buy more mahogany, I do not have a low cost, reliable source for this. I hate wasting guitar neck blanks to make a uke neck, but not much I can do...

So far all I am doing is prep the plates:

Image

Image

Author:  Quine [ Fri Sep 28, 2012 4:28 pm ]
Post subject:  Re: New tenor ukelele build

Nice looking wood find.

You can download a template from Stew Mac.... http://www.stewmac.com/shop/Kits/Ukulel ... structions

Just print it out.

Author:  Tai Fu [ Fri Oct 05, 2012 4:28 am ]
Post subject:  Re: New tenor ukelele build

Image

Whittling the wood down to its proper thickness. Planning around .06" on the side, .09" on the back and top. I was able to thickness the back and side close to its finished thickness with the Wagner Safe T Planer but it threw dust everywhere. I still need to finish it off with hand planes (the thing leaves some deep marks) and sanding.

The top will be whittled down by hand, it sure planes a lot easier than Padauk. It's very thick to begin with so this might take a while. Last time I measured it was around .160"

Author:  Tai Fu [ Fri Nov 02, 2012 1:42 am ]
Post subject:  Re: New tenor ukelele build

Quine wrote:
Nice looking wood find.

You can download a template from Stew Mac.... http://www.stewmac.com/shop/Kits/Ukulel ... structions

Just print it out.


Can you tell me what is the depth at the tail and heel? I can't find this information in the instruction.

Author:  Tai Fu [ Fri Nov 02, 2012 8:36 am ]
Post subject:  Re: New tenor ukelele build

I was a little busy so I didn't touch the project for a while... here is some progress: I have sanded the pieces to the right thickness (or close to it) and made a mold

Image

Author:  DennisK [ Fri Nov 02, 2012 9:01 am ]
Post subject:  Re: New tenor ukelele build

Looking good! Here's an image I found online somewhere a long time ago, which is quite handy for uke designing:

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/