| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Grizzlies 10 inch drum sander? http://luthiersforum.com/forum/viewtopic.php?f=10128&t=51379 |
Page 1 of 1 |
| Author: | Steve-atl [ Thu Dec 27, 2018 10:11 am ] |
| Post subject: | Grizzlies 10 inch drum sander? |
Grizzlies 10 inch drum sander is on sale for $618 shipped. The problem is it only sands down to a 1/4". I guess I could use a backing board when I needed to sand something thinner but that seems like a hassle. Any drum sander I should be looking at. Yes, the cost is a consideration.  Thank you http://www.grizzly.com/products/Grizzly ... oEALw_wcB# |
|
| Author: | Ruby50 [ Thu Dec 27, 2018 10:50 am ] |
| Post subject: | Re: Grizzlies 10 inch drum sander? |
You might move this to the Guitar Building page for more responses. I just bought a used Performax 16/32. So far I like it a lot Ed |
|
| Author: | Steve-atl [ Thu Dec 27, 2018 1:28 pm ] |
| Post subject: | Re: Grizzlies 10 inch drum sander? |
Ruby50 wrote: You might move this to the Guitar Building page for more responses. I just bought a used Performax 16/32. So far I like it a lot Ed That's funny I was just talking with a guy about a used Performax 16/32. So you like it? Thanks |
|
| Author: | Pmaj7 [ Thu Dec 27, 2018 2:52 pm ] |
| Post subject: | Re: Grizzlies 10 inch drum sander? |
They always say minimum thickness is 1/8 or more, but it seems like everyone is able to sand much thinner. I've never heard of anyone using that particular one. I had the jet 1020 and I was able to go down to less than a 1/16. The same on several larger ones. New username, same Pat Mac |
|
| Author: | Steve-atl [ Thu Dec 27, 2018 3:31 pm ] |
| Post subject: | Re: Grizzlies 10 inch drum sander? |
Pmaj7 wrote: They always say minimum thickness is 1/8 or more, but it seems like everyone is able to sand much thinner. I've never heard of anyone using that particular one. I had the jet 1020 and I was able to go down to less than a 1/16. The same on several larger ones. New username, same Pat Mac What are tops sanded down to? It seems like you could make a sled if you wanted to go thinner. Maybe some MDF with sandpaper glued on. would that work? |
|
| Author: | Pmaj7 [ Thu Dec 27, 2018 3:47 pm ] |
| Post subject: | Re: Grizzlies 10 inch drum sander? |
.09" sure you could, but no need I think. New username, same Pat Mac |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|