Official Luthiers Forum!
http://luthiersforum.com/forum/

First Solo Build Dred based on Martin Herringbone Plans
http://luthiersforum.com/forum/viewtopic.php?f=10130&t=44393
Page 1 of 1

Author:  KThomas [ Wed Oct 22, 2014 7:05 pm ]
Post subject:  First Solo Build Dred based on Martin Herringbone Plans

Hi,

This has been a project long in the making. I promised a guitar to my brother for a Christmas present about 3 years ago, I had the wood but not all the tools and materials I needed to get it going. So, once I did, I dug in and documented the whole thing on my YouTube channel so he could watch from his home in Atlanta. I live up near Buffalo. Anyway, the guitar is done, currently not finished. I am in the stages of doing a french polish finish on it using U-Beaut shellac, based on Steve from VA's method. He has been over the top helpful on this and I appreciate all his help, input and patience with me.

Here's the link to the first video, but let me warn you, it's not Breaking Bad but probably would run about the same amount of seasons if televised.

https://www.youtube.com/watch?v=p4pQ0u5 ... Q3cc5y_bV5

Kurt

Author:  dzsmith [ Wed Oct 22, 2014 8:08 pm ]
Post subject:  Re: First Solo Build Dred based on Martin Herringbone Plans

Kurt, the video is a really cool idea!
I bet your brother will enjoy watching it!
Dan

Author:  KThomas [ Thu Oct 23, 2014 7:29 pm ]
Post subject:  Re: First Solo Build Dred based on Martin Herringbone Plans

Thanks Dan, yes he has really enjoyed it and he can't wait to get his hands on it. I have it almost finished, about 30 sessions French Polish on the back and sides, but none on the top due to a problem with the rosette that I ran into. I had resanded the top and got too thin at one of the purfling lines around the rosette, so now I am waiting for a circle cutter and will try to re-route the bad purfling out and replace it. Will be tricky.

Kurt

Author:  dzsmith [ Thu Oct 23, 2014 8:24 pm ]
Post subject:  Re: First Solo Build Dred based on Martin Herringbone Plans

KThomas wrote:
Thanks Dan, yes he has really enjoyed it and he can't wait to get his hands on it. I have it almost finished, about 30 sessions French Polish on the back and sides, but none on the top due to a problem with the rosette that I ran into. I had resanded the top and got too thin at one of the purfling lines around the rosette, so now I am waiting for a circle cutter and will try to re-route the bad purfling out and replace it. Will be tricky.

Kurt

Good luck, Kurt!
Dan

Author:  flounder [ Fri Oct 24, 2014 1:51 am ]
Post subject:  Re: First Solo Build Dred based on Martin Herringbone Plans

Hi Kurt,
I subscribed to your channel ages ago and have really enjoyed following your progress.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/