| Official Luthiers Forum! http://luthiersforum.com/forum/ |
|
| Buff A Satin MexiMartin to High Gloss? http://luthiersforum.com/forum/viewtopic.php?f=10137&t=51579 |
Page 1 of 1 |
| Author: | Kbore [ Fri Feb 08, 2019 5:06 pm ] |
| Post subject: | Buff A Satin MexiMartin to High Gloss? |
Could a Mexican Martin Custom X model Dread be buffed out to a gloss, by polish sand and buff? |
|
| Author: | Freeman [ Fri Feb 08, 2019 8:11 pm ] |
| Post subject: | Re: Buff A Satin MexiMartin to High Gloss? |
X model Martins have a HPL back and sides, spruce top. At least the one that I just repaired did. The finish on the top looks pretty thin, I don't know if there is enough there to buff, I rather doubt it. The back has a mahogany looking wood grain in the outer layer - I don't think there is any finish at all. Can it be buffed? I don't know, probably wouldn't hurt to try. The one I worked on had been dropped and the back to side seam had been split. A piece of the back had been broken out - I was able to put it all back together with CA. I lightly sanded some of the edges of the broken piece and got a white line indicating that I had sanded thru the outer "wood" layer. I did some drop filling with CA, scraped back level and went over the repair with 0000 steel wool to restore the satin finish. |
|
| Author: | B. Howard [ Sat Feb 09, 2019 6:38 am ] |
| Post subject: | Re: Buff A Satin MexiMartin to High Gloss? |
There is no finish on those Formica guitars. The white line was the bottom of the plastic laminate on top of the phenolic base. It's basically kitchen counter material..... |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|