Official Luthiers Forum!

Owned and operated by Lance Kragenbrink
It is currently Thu Mar 28, 2024 3:29 pm


All times are UTC - 5 hours





Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sun May 24, 2015 9:15 pm 
Offline
Cocobolo
Cocobolo

Joined: Tue Feb 17, 2015 6:03 pm
Posts: 165
First name: Glenn
Last Name: Aycock
City: El Lago
State: Texas
Zip/Postal Code: 77586
Country: United States
Focus: Build
Status: Amateur
Just finished this jig - based on similar designs I've seen around various luth forums. Looks promising but it still needs a few tweaks.

Image

The router itself is questionable, but I didn't want to permanently mount my good PC router on it.

Tomorrow I'm going to put a larger bit on it and add a dust collection port.


Sent from my iPhone using Tapatalk


Top
 Profile  
 
PostPosted: Mon May 25, 2015 10:02 am 
Offline
Cocobolo
Cocobolo

Joined: Tue Feb 17, 2015 6:03 pm
Posts: 165
First name: Glenn
Last Name: Aycock
City: El Lago
State: Texas
Zip/Postal Code: 77586
Country: United States
Focus: Build
Status: Amateur
Works much better with a 1/2" straight cut bit instead of a 1/4" spiral cutter. The depth keeps slipping. I'm not sure if it's the collet or the base. What a piece of crap.


Sent from my iPhone using Tapatalk



These users thanked the author Glenn_Aycock for the post: Bri (Tue Jun 02, 2015 9:14 am)
Top
 Profile  
 
PostPosted: Mon May 25, 2015 4:55 pm 
Offline
Cocobolo
Cocobolo

Joined: Tue Feb 17, 2015 6:03 pm
Posts: 165
First name: Glenn
Last Name: Aycock
City: El Lago
State: Texas
Zip/Postal Code: 77586
Country: United States
Focus: Build
Status: Amateur
After replacing the wing nut with a lock nut and tightening everything up, it works much better.

Still not 100% - there's a bit of flex somewhere that throws the cuts off. I may try a round nose bit.


Top
 Profile  
 
PostPosted: Tue May 26, 2015 12:15 pm 
Offline
Cocobolo
Cocobolo

Joined: Tue Feb 17, 2015 6:03 pm
Posts: 165
First name: Glenn
Last Name: Aycock
City: El Lago
State: Texas
Zip/Postal Code: 77586
Country: United States
Focus: Build
Status: Amateur
Got it dialed in now - with the straight cutter. Round nose bit not recommended.

Turned out to be an engineering problem. The upright was flexing due to my downward pressure as I swung the router. I reinforced it and added a handle close to the side to minimize flexing. It works reasonably well now.

I can't really say it was economical, but I can make blocks in any length and radius up to 22".


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group
phpBB customization services by 2by2host.com