Official Luthiers Forum!
https://luthiersforum.com/forum/

Tailpiece update
https://luthiersforum.com/forum/viewtopic.php?f=10106&t=39808
Page 1 of 1

Author:  dberkowitz [ Fri Mar 22, 2013 6:57 pm ]
Post subject:  Tailpiece update

I just got the tailpiece for the doubleneck project from the machine shop. In a word, they did a fantastic job. I had a little bit of sanding to do before I put it in the tumbler to matte the finish before anodizing.

I want to give a shout out to Brian Hess, and the folks at Astro Machine Works, http://www.astromachineworks.com, whose bid was several times less than other proposals. They were great to work with. I highly recommend them.

Author:  Bob Garrish [ Fri Mar 22, 2013 7:28 pm ]
Post subject:  Re: Tailpiece update

Pics!

Author:  Chris Pile [ Fri Mar 22, 2013 10:11 pm ]
Post subject:  Re: Tailpiece update

Quote:
Pics!


^^^^^ What Bob said. ^^^^^

Author:  Andy Birko [ Sat Mar 23, 2013 7:14 am ]
Post subject:  Re: Tailpiece update

Or it didn't happen!

Author:  dberkowitz [ Sat Mar 23, 2013 7:26 am ]
Post subject:  Re: Tailpiece update

Alas, I won't post pictures until the whole project is done. I deliberately didn't have it anodized until it gets fitted to the body so there would be no risk of getting it scratched. There is a possibility of an article, so in deference to the publisher I can't post pictures. Rest assured, the part exists much to my relief.

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/