| Official Luthiers Forum! https://luthiersforum.com/forum/ |
|
| Trimmed My HeadStock to Final Shape https://luthiersforum.com/forum/viewtopic.php?f=10122&t=25600 |
Page 1 of 1 |
| Author: | Darryl Young [ Thu Jan 21, 2010 12:15 am ] |
| Post subject: | Trimmed My HeadStock to Final Shape |
I'm very happy that I was able to get the oversized headstock on my guitar neck cut to shape without messing anything up! My neck has a smilee volute so not really a standard Martin shape.....but regardless, I went with the Martin shaped headstock. I made a template from UHMW and used it to draw trim lines on the neck. I made the cuts with my table saw.....which is a little awkward since the taper angles the blade toward the neck. Thankfully, there was enough clearance to use the table saw. I even placed a screw on the side of the UHMW template and used it between the table saw fence and headstock while making the final cut. In the end, I trimmed the headstock close to final shape then sanded the last 0.030" or so. Here is a pic of the UHMW template I made. I may later add the tuner holes. Attachment: HeadStockTemplate.JPG And here is a couple of shots of the trimmed headstock (which looks a little odd with the smilee volute, ha): Attachment: HeadStock1.JPG Attachment: HeadStock2.JPG Attachment: HeadStock3.JPG
|
|
| Author: | Stephen Boone [ Thu Jan 21, 2010 9:37 am ] |
| Post subject: | Re: Trimmed My HeadStock to Final Shape |
That looks very nice! |
|
| Author: | Hesh [ Thu Jan 21, 2010 12:23 pm ] |
| Post subject: | Re: Trimmed My HeadStock to Final Shape |
Looks great Darryl! |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|