Official Luthiers Forum!Owned and operated by Lance Kragenbrink |
| It is currently Mon Aug 11, 2025 10:21 pm |
|
All times are UTC - 5 hours |
 
|
Page 1 of 1 |
[ 1 post ] |
|
| Author | Message | ||||||
|---|---|---|---|---|---|---|---|
| Goodin |
|
||||||
Joined: Mon Dec 20, 2010 7:15 pm Posts: 1041 First name: Gil Last Name: Draper City: Knoxville State: Tennessee Country: USA Focus: Build Status: Professional |
|
||||||
| Top |  |
||||||
 |
|||||||
|
|
Page 1 of 1 |
[ 1 post ] |
|
All times are UTC - 5 hours |
Who is online |
Users browsing this forum: No registered users and 11 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |
Login
Register
FAQ
. Does anyone know of a cheap bench buffer or buffer/grinder or grinder that I can use as a buffer that will accept a 2" wide wheel? I want to use a 3M Scotch Brite finishing wheel to clean up the blades and chip breaker on my hand plane restoration project. The wheel meaures 2" wide and 6" in diameter and is just barely too wide to fit on my Harbor Freight bench buffer. Ive looked around and tried to find a buffer with longer shafts, at least at the end where its threaded, but cant find anything. Thanks for any advice.